Cambridge Pavers Home Additions & ADU Nationwide

Cambridge Pavers Home Additions & ADU: The Pompano Beach Owner’s Guide

Cambridge Pavers home additions and ADU construction in Pompano Beach typically runs $45,000-$130,000 for standard additions and $90,000-$220,000 for detached ADUs, with most projects quoted within 48 hours and permitting initiated immediately upon approval. We stock and install Cambridge Pavers-compatible hardscape systems for outdoor living spaces integrated into home additions and ADU builds throughout Pompano Beach, including the full ArmorTec and Permeable Paver lines. Most owners discover their paver system needs attention when settling, drainage failure, or joint sand loss appears after heavy rain - common in Pompano Beach’s sandy coastal substrate and high water table conditions.

Call (754) 714-6540

Which Cambridge Pavers Models This Applies To

Cambridge Pavers manufactures several product lines relevant to home addition and ADU hardscape integration in Pompano Beach. The ArmorTec line - their standard through-body paver with a color-hard layer - is what we see most often on older Pompano Beach additions near the Intracoastal, installed between 2010 and 2018. The Permeable Paver series, required for many newer ADU driveway and patio applications under Broward County stormwater rules, uses a wider joint spacing (typically 3/16 inch versus 1/8 inch for standard) and requires specific ASTM C936 compliance documentation for permit approval.

To identify your system, check the edge of any lifted paver for the Cambridge stamp - it appears on one corner of most units manufactured after 2012. Pre-2012 stock often lacks marking and requires visual matching against Cambridge’s archived spec sheets, which we maintain in our Pompano Beach office. The OEM versus aftermarket question here is straightforward: Cambridge’s ArmorTec color formulations are proprietary, so exact color matching for repairs demands Cambridge-sourced units or full-section replacement. For structural base components - the aggregate sub-base, geotextile fabric, edge restraints - we use equivalent-grade materials from Belgard and Techo-Bloc that meet or exceed Cambridge’s published specs and carry the same installation warranty.

Signs Your Cambridge Pavers Home Additions & ADU Is Failing

• Sunken or tilted pavers near downspout outlets. The base aggregate has washed out or compacted unevenly, usually because the original installer used too fine a stone (limestone screenings instead of ASTM C33 concrete sand) for Pompano Beach’s drainage demands. Water follows the path of least resistance and undermines the bedding layer.
• White haze or efflorescence blooming across the surface. Calcium hydroxide is migrating through the paver body - common in Florida’s humid climate and accelerated by irrigation overspray. It does not indicate structural failure but signals that the paver’s pore structure is more open than specified, which accelerates future degradation.
• Joint sand washing out repeatedly after rain. The polymeric sand bond has failed, either from improper initial activation (water applied too heavily, too soon) or from using standard sand where polymer-modified was specified. In Pompano Beach, we see this most on south-facing ADU patios where thermal cycling is extreme.
• Edge restraints pulling away from the perimeter. Plastic or aluminum edging spikes have corroded or loosened in the sandy Pompano Beach substrate, allowing the field to spread. Once the edge goes, the interlock fails and the center begins to telegraph the problem within two to three rainy seasons.
• Pooling water that did not occur originally. The original pitch (typically 1/8 inch per foot minimum) has been lost to base settlement or root intrusion from nearby oak or ficus - both aggressive in Pompano Beach’s growing season. Standing water accelerates paver saturation and freeze-thaw damage, even in Florida’s mild winters.

Before

After

Replacement Cost & What’s Included

Our quotes for Cambridge Pavers work in Pompano Beach include demolition and disposal of failed material, recompaction of the native substrate with plate tamper to 98% Proctor density, new geotextile separation fabric, ASTM C33 bedding sand, the specified Cambridge or equivalent paver units, polymeric joint sand with controlled activation, and aluminum edge restraint with spiral steel spikes. Under Clause 1 of the Haven Standard, the written price covers everything described - no change proceeds without a signed change order, which is why our projects finish within a few percent of the agreed number. The 365-Day Done Right Promise applies to all paver installation work.

DIY or Call Us?

An owner can safely assess what’s failing: lift one paver at the edge (wear gloves, use a flat pry bar), photograph the base layers, and check for standing water or root intrusion. What you find tells us most of what we need to know for the initial quote.

Where DIY goes wrong is in the base reconstruction. Removing and recompacting aggregate to the correct density requires a plate tamper (not a hand tamper) and moisture control that most rental equipment lacks. More critically, Cambridge Pavers’ interlock system depends on precise edge restraint installation - too shallow and the field spreads; too deep and you trap water against the foundation of your home addition or ADU. We’ve repaired three Pompano Beach owner-installed jobs in the past eighteen months where the base was sound but the edge failed within a year. For the diagnosis, call us; for the fix, we recommend professional installation to preserve your structure’s warranty and your time. Call (754) 714-6540 to schedule your free estimate.

FAQs