Boral Roofing Nationwide

Boral Roofing: The Pompano Beach Owner’s Guide

Boral concrete and clay tile roofing in Pompano Beach typically runs $600-$2,500 for targeted repairs and $8,000-$20,000 for full replacement, with most common part failures addressable same-day when we have your series on file. We stock Boral-compatible underlayment, battens, hip and ridge accessories, and replacement tiles for the most common South Florida profiles. Most Pompano Beach homeowners discover a Boral part has failed after a hard rain reveals a leak in the living space, or when they spot cracked tiles along the rake edge where afternoon sun exposure is harshest.

Call (754) 714-6540

Which Boral Models This Applies To

Boral’s U.S. roofing division, now operating as Boral Roofing under Westlake Royal Roofing Solutions, produced several distinct product lines that remain in service across Pompano Beach. The Saxony 900 and Saxony Slate concrete tile lines are the most common in our market, followed by the Smoothtex and Double S profiles on homes built between 1995 and 2015. Clay tile models include the Barcelona 900 and the two-piece Mission S, both of which we see frequently in the older neighborhoods near Pompano Beach’s historic district where Spanish Revival architecture was specified.

To identify your exact part, locate the manufacturing date stamp on the underside of an intact tile; it reads as a four-digit code (week and year) alongside the plant code. The critical compatibility gotcha in Pompano Beach is the fastening system: pre-2008 Boral concrete tiles used a 10-inch nail penetration standard, while post-2008 production shifted to an enhanced fastening pattern for High Velocity Hurricane Zone compliance. Mixing the nail lengths or batten spacing between these eras voids the wind warranty and creates a point failure under uplift pressure. We source OEM Boral replacement tiles where the color run is still active; for discontinued color lots, we match to quality aftermarket equivalents from Westlake Royal’s current production and document the substitution in your photo record.

Signs Your Boral Roofing Is Failing

• Cracked or broken tiles at the rake edge or hip lines. These are the highest-stress zones on any pitched roof in Pompano Beach, where sustained easterly winds from the Atlantic create flexion cycles. A single cracked tile exposes the underlayment beneath, and once that asphalt-saturated felt degrades, water tracks directly to the plywood deck.
• Granule accumulation in gutters or at downspout exits. Boral concrete tiles carry a colored surface coat; when you see heavy granule shedding, the tile body is beginning to chalk. This is accelerated by the salt-laden air in Pompano Beach, and it signals that the protective layer has thinned to the point where moisture will begin wicking into the tile substrate.
• Lifted or displaced tiles after a storm event. Even if the tile itself is intact, displaced tiles indicate a fastener failure at the batten or a degraded nail. In Pompano Beach’s HVHZ, a single lifted tile creates a pressure differential that can unzip adjacent courses during the next storm.
• Water stains on interior ceilings that align with valley or penetration locations. Boral roofs rely on a secondary membrane at valleys, pipe boots, and chimney saddles. When the primary tile drainage path is compromised, these membranes carry the load until they fatigue, typically at 15-22 years in Florida’s UV exposure.
• Soft or spongy decking felt from the attic side. If you can safely access your attic and press the plywood near a fastener line, any give indicates the underlayment has failed and moisture has reached the deck. This is past the point of tile-only repair; the substrate needs inspection.

Before

After

Replacement Cost & What’s Included

The range depends on three factors we assess during your free estimate: the square footage of affected area, whether the original battens are salvageable or have rotted at the fastener lines, and whether your HOA or municipal inspector requires a full-nail-off versus an recover. Under Clause 1 of the Haven Standard, you receive a written line-item quote before any work starts; the price includes all Boral-compatible materials, labor, permit pulling, and disposal. Our 365-Day Done Right Promise covers the workmanship, and we register any applicable manufacturer warranty on your behalf.

DIY or Call Us?

A homeowner can safely perform ground-level observation: photograph cracked tiles from a ladder at gutter height, check attic spaces for active leaks during rain, and clear debris from valleys using a leaf blower on low. What you should not attempt is walking the tile surface. Boral concrete and clay tiles are not structural; they crack under concentrated foot pressure, and a broken tile underfoot creates a sudden fall hazard on a pitched surface. The fastener replacement requires removing adjacent tiles to access the batten, then reseating with proper overlap, a process that demands experience with the specific Boral profile to avoid chipping the interlock edges. For anything beyond visual inspection, call (754) 714-6540. We carry the correct nails, the foam adhesive backup, and the tile hooks on every roofing truck.

FAQs