Toto Bathroom Remodeling Nationwide

Toto Bathroom Remodeling: The Pompano Beach Owner’s Guide

Toto bathroom remodeling in Pompano Beach typically runs $9,000-$28,000 for a full renovation with Toto fixtures installed, and we stock the full Toto catalog through our supplier network with most orders arriving within 48 hours. Most Pompano Beach homeowners find us after a Toto toilet, faucet, or shower valve starts leaking, running, or failing to seal - often in homes built during the 2005-2015 boom when Toto’s Drake and Ultramax II lines were spec’d heavily by South Florida builders. We carry common Toto replacement cartridges, flappers, and fill valves on our trucks for same-day stops, and we pull permits through the City of Pompano Beach Building Department when the scope requires it.

Call (754) 714-6540

Which Toto Models This Applies To

Toto’s product ecosystem breaks into several series, and matching the right part matters more than with most brands because Toto uses proprietary dimensions on many components. The Drake CST744E and CST454CEFG, the Ultramax II MS604114CEFG, and the Promenade II CST824TF are the three lines we see most often in Pompano Beach homes, particularly in neighborhoods like Harbor Village and the condos along the Intracoastal where those models were builder-standard from roughly 2008 to 2018.

To identify your model, lift the tank lid and look for a four-digit CST or MS number stamped into the porcelain - not the sticker on the tank wall, which is often a generic Toto USA label. The stamped number is the series identifier. For faucets and shower trim, the model number is etched into the escutcheon plate or printed on the cartridge itself. Toto’s THU series flappers (THU500S, THU331S) and TSU series fill valves are model-specific - a Drake flapper will not seal on an Ultramax II because the flush valve diameter differs by 1/8 inch, enough to cause a slow leak that wastes 50 gallons a week.

We source OEM Toto parts through our Ferguson and Hajoca supply houses. Aftermarket equivalents exist from Fluidmaster and Korky, and we will install them if a customer requests - but we note in the written quote that the Toto warranty on the fixture itself requires OEM parts to remain valid. Measure twice, say it once, show your work.

Signs Your Toto Bathroom Remodeling Is Failing

• Phantom flushing or tank refilling every 20-30 minutes. The flapper seal has degraded, which in Pompano Beach happens faster than the national average because municipal water here runs harder than in most Florida cities - calcium buildup on the flush valve seat prevents a clean seal even if the rubber itself looks intact.
• Weak flush that requires holding the handle down. The flapper chain is out of spec or the fill valve’s refill tube is misrouted, but more often the 3-inch flush valve gasket (THU4077 on Drake models) has compressed after years of heat cycling in unventilated Florida bathrooms.
• Water pooling at the base of a one-piece Toto. The molded trapway seal has failed - common in the Ultramax II after 8-12 years in our climate because the wax or rubber seal degrades faster with the temperature swings from AC cooling and humidity spikes. This is not a part failure to ignore; subfloor damage in Pompano Beach’s older CBS construction spreads quickly.
• Shower valve temperature drifting or scalding. The Toto TS6A or TS9A pressure-balance cartridge has lost its O-ring integrity. Hard water here scores the ceramic discs, and once scoring starts, the cartridge cannot be cleaned - only replaced.
• Faucet handle loosening or grinding. The Toto TL210 or TL220 series uses a ceramic disc cartridge (THU4440) that should rotate smoothly for 15-plus years. Grinding means sediment has breached the seal, which happens when homeowners skip the supplied inline filter during original installation.

Before

After

Replacement Cost & What’s Included

The range depends on three factors: whether the part is on our truck today (common cartridges and flappers are), whether the fixture is a one-piece Toto requiring full removal versus a two-piece allowing in-tank service, and whether the City of Pompano Beach requires a permit - which they do for any valve replacement behind the wall or any fixture relocation. Under Clause 1 of the Haven Standard, the written price covers everything described; no change proceeds without a signed change order. Our 365-Day Done Right Promise applies to all Toto work, and every visit includes a documented photo record of before, during, and after - standard, not an upgrade.

DIY or Call Us?

There is safe DIY and there is false economy. A homeowner can replace a Toto flapper or fill valve with a screwdriver and ten minutes - we have no interest in charging for that. But the 3-inch flush valve seal on a Drake requires dropping the tank from the bowl, and the one-piece Ultramax II requires removing the entire fixture from the flange. Both involve water shutoffs, old supply lines that may not reseal, and a wax ring that cannot be reused.

Shower valve cartridges sit behind trim plates that are often siliconed to tile; prying without cracking the surrounding grout takes a feel for the tool angle that comes from repetition. We have replaced enough Toto cartridges in Pompano Beach condos to know which buildings have the original 2008 copper sweats versus the later PEX retrofits - and which shutoff valves in the hallway access panel are seized from salt air.

If you are unsure which Toto model you have or whether the part is on our truck, call (754) 714-6540. We will walk you through finding the stamped model number, and if it is a five-minute fix, we will tell you so. Estimates are free, and we deliver a written price before any work starts.

FAQs