Free written scope consultation - allowances, timeline, and change-order rules on paper before a single trade is scheduled
Before
After
Before
After
Before
AfterHow Much Does Patio Door Installation Cost in Pompano Beach?
Patio door installation in Pompano Beach typically costs between $1,800 and $6,500, with most homeowners landing in the $2,500 to $4,200 range depending on door type, glass specification, and frame condition. Impact-rated sliding doors – the most common choice in Broward County given Florida Building Code requirements for wind-borne debris resistance – run $2,800 to $5,500 installed, while French door configurations and folding multi-panel systems push the upper end of the range. At Rowan Construction Group, every quote is a flat written price with a written scope before any work begins, under Clause 1 of the Haven Standard.
Patio Door Installation Cost Breakdown (2026)
Patio door installation in Pompano Beach costs between $1,800 and $6,500 for most residential projects. The table below reflects current Broward County labor rates and material pricing as of 2026. Impact-rated units carry a price premium over standard tempered glass, but in Pompano Beach that upgrade is often required by code – and nearly always required by your insurance carrier.
| Door Type / Scenario | Typical Installed Cost (Pompano Beach, 2026) |
|---|---|
| Standard sliding glass door, non-impact (replacement) | $1,800 – $2,800 |
| Impact-rated sliding door, single panel pair (6 ft.) | $2,800 – $4,200 |
| Impact-rated sliding door, wider panel (8 ft.) | $3,200 – $5,000 |
| Impact French doors (double, hinged) | $3,500 – $5,500 |
| Folding / bi-fold patio door system (multi-panel) | $5,000 – $6,500+ |
| Pocket sliding door (wall integration required) | $4,200 – $6,000 |
| Frame-only repair + hardware swap (no new door) | $400 – $950 |
| Rough opening modification / structural header work | $600 – $2,200 (add-on) |
| Permit fee (City of Pompano Beach) | $150 – $350 (typical residential) |
| Stucco / drywall repair around opening (if needed) | $250 – $800 (add-on) |
Labor accounts for roughly 30 to 40 percent of the total on a straightforward replacement in a standard 6-foot opening. Where that percentage climbs is when the existing rough opening needs modification – a common finding in Pompano Beach’s older Coral-style and mid-century concrete block homes east of Federal Highway, where openings were framed for narrower aluminum sliders in the 1970s and 1980s. Adding width means cutting block or wood framing, installing a new structural header, and finishing both the interior drywall and the exterior stucco. That structural work is where the “add-on” line items above apply. Every Rowan crew documents the condition of the existing opening with photographs before demolition begins, so there are no surprises after the old door is out.
What Affects Patio Door Installation Pricing in Pompano Beach
- Impact rating vs. standard glass: Florida Building Code Section 1609 requires wind-borne debris protection in Broward County’s wind-speed zones. In most of Pompano Beach, that means either impact-rated glazing (laminated glass bonded to a PVB interlayer) or a code-compliant shutter system covering a standard unit. An impact-rated door costs $400 to $1,200 more than a comparable non-impact unit – but it eliminates the need for shutters, which many homeowners prefer, and it almost always earns a premium discount on homeowners’ insurance.
- Door width and panel configuration: A standard 6-foot, two-panel sliding unit is the least expensive configuration. Moving to an 8-foot or 10-foot opening – popular in newer construction near the Intracoastal and in the Cypress Bend area – adds glass area, hardware complexity, and frame material cost. Folding multi-panel systems (sometimes called lift-and-slide or bi-fold) use a different track system entirely and add $1,500 to $2,500 over a comparable sliding unit.
- Frame material: Aluminum frames with a thermal break are the most common choice in Pompano Beach – they resist the salt-air corrosion that shortens the life of untreated steel and they meet Florida Energy Code U-factor requirements more easily than plain aluminum. Vinyl frames cost slightly less upfront but can warp under sustained South Florida heat when the glazing is dark-tinted. Fiberglass frames perform well in both categories but add 15 to 25 percent to the door price.
- Rough opening condition: Concrete block construction (CBS) is common throughout Pompano Beach’s neighborhoods west of US-1, and cutting or modifying a CBS opening requires masonry tools, a structural lintel, and additional finishing time. Wood-frame homes, more prevalent in the older sections of Deerfield Beach Road and Pompano Estates, are faster to modify but need careful rot inspection around the existing sill before a new unit goes in.
- Low-E glass specification and SHGC: Florida Energy Code requires a Solar Heat Gain Coefficient (SHGC) of 0.25 or lower for replacement doors in climate zones like Pompano Beach’s. Most impact-rated units from brands like PGT WinGuard and CGI SentryGlas already meet this spec, but it is worth confirming – a door that fails inspection means a return visit and a re-inspection fee. Low-E coatings that meet both the SHGC and the U-factor requirement typically add $100 to $300 to the glass cost.
- Access and logistics: Installing a patio door into a second-floor unit or a condo above the first level in one of Pompano Beach’s oceanside buildings adds equipment time and sometimes elevator-use coordination with the building. Ground-floor installs in single-family homes are the baseline; anything that requires a lift, scaffolding, or building management coordination adds $200 to $600 to the labor estimate.
Before
AfterHow to Save on Patio Door Installation in Pompano Beach
The single most useful thing a Pompano Beach homeowner can do before signing a contract is get a written, itemized quote – not a verbal ballpark. Vague estimates protect the contractor, not the customer. Under the Haven Standard, Rowan Construction Group delivers a flat written price with a written scope before any work starts. That price is what you pay, and no change proceeds without a signed change order first. Bring a competitor’s written quote and we’ll review it line by line at no charge – that’s the Free Second Opinion offer, and it exists because line-item comparison is the fastest way to find inflated material markups.
Beyond that, here are the practical moves that actually reduce cost without cutting quality:
- Choose a direct replacement over a rough-opening expansion. If the existing opening is already the size you want, keeping the same rough opening dimensions avoids header work, structural modification, and the stucco or drywall repair that follows. On concrete block homes in Pompano Beach this alone can save $600 to $1,800.
- Bundle with window work. If you’re also planning window replacement – a common pairing given Florida’s insurance inspection requirements – scheduling both at once reduces the per-visit mobilization cost and keeps the permit to a single pull. Impact window installation in Pompano Beach runs $8,000 to $25,000 for a whole-home project; combining a patio door into that scope typically costs less than pricing the door separately.
- Ask specifically about discontinued or clearance inventory. Brands like PGT, CGI, and Andersen regularly carry builder-grade impact units in standard sizes (6-foot slider, white frame, clear Low-E glass) that come at a meaningful discount over custom-color or special-size orders. If your opening fits a stock size, there is no reason to order custom.
- Time your project outside peak season. South Florida’s construction season peaks from October through April when snowbird renovations and insurance-driven replacements stack up. Scheduling in May or June typically means shorter lead times on permits and faster crew availability – and some contractors price accordingly. Lead time on impact units from Florida-based manufacturers currently runs four to eight weeks; ordering in the off-season often cuts that to two to three weeks.
- Verify your permit requirement before skipping it. Some homeowners consider skipping the permit to save the $150 to $350 fee. In Pompano Beach, that’s a short-sighted trade: an unpermitted door replacement can appear on a 4-point inspection when you refinance or sell, require removal and reinstallation at your expense, and void your manufacturer warranty. The permit is not optional on a structural opening – treat it as part of the project cost.
Call (754) 714-6540 for a free written estimate. The quote comes with a line-item scope and a flat price – no “call for a quote” back-and-forth.
Key Takeaways
- Most patio door installations in Pompano Beach cost $2,500 to $4,200 for a standard impact-rated sliding unit installed in an existing opening.
- Impact-rated glazing is effectively required in Broward County under Florida Building Code and by most insurance carriers – budget for it from the start.
- Rough-opening modification on Pompano Beach’s common concrete block homes adds $600 to $2,200 to the base cost.
- A permit is required for structural opening work in the City of Pompano Beach; fees run $150 to $350 for typical residential projects.
- Get a written, itemized quote before any work starts. Under the Haven Standard, Rowan delivers this as standard – not on request.
- The 365-Day Done Right Promise covers workmanship: if it is not right, Rowan makes it right, backed in writing.
FAQs – Patio Door Installation Cost in Pompano Beach
How much does it cost to replace a sliding glass patio door in Pompano Beach?
Replacing a standard sliding glass patio door in Pompano Beach costs $2,800 to $4,200 installed for a 6-foot, impact-rated unit in an existing rough opening – assuming no structural modification is needed. Non-impact standard glass units run $1,800 to $2,800, but most Pompano Beach homeowners opt for impact-rated given Broward County’s wind-speed zone requirements and insurance carrier expectations. Call (754) 714-6540 for a flat written estimate; we’ll measure the opening, assess the frame condition, and give you a number before any work starts.
Do I need a permit to install a patio door in Pompano Beach, FL?
Yes – any patio door installation that touches or modifies a structural opening in the City of Pompano Beach requires a building permit. The typical residential permit fee runs $150 to $350, and the work must be performed by a licensed contractor and pass a final inspection. Skipping the permit is a risk that can surface during a 4-point inspection at sale or refinance and may require full removal and reinstallation. Rowan pulls the permit as part of every patio door project – it is included in the written scope, not added later as a surprise line item.
How long does patio door installation take?
A straightforward patio door replacement – removing the existing unit, installing the new impact-rated door in the same opening, and finishing the interior and exterior trim – takes one full day in most cases. Projects that require rough-opening modification in concrete block construction add one to two additional days for masonry work, header installation, and stucco repair. Lead time on the door unit itself (ordered from manufacturers like PGT WinGuard or CGI) currently runs four to eight weeks in Pompano Beach’s market; ordering during the off-season can reduce that.
Is it cheaper to repair or replace a patio door in Pompano Beach?
Frame-only repair and hardware replacement runs $400 to $950, which makes sense if the glass is intact, the frame is structurally sound, and the door is already impact-rated to current code. If the existing door is a non-impact unit, has a damaged frame, shows corrosion at the sill (common in Pompano Beach homes within a mile of the ocean), or is failing its seal so condensation appears between the glass panes, replacement is the more cost-effective call over a three-to-five-year horizon. Rowan’s crews photograph the frame condition before any quote is written so you have documentation of what was found – not just a recommendation to replace based on what’s profitable for the contractor.
What is the best type of patio door for Pompano Beach’s climate?
An impact-rated aluminum sliding door with a thermal break and a Low-E coating rated SHGC 0.25 or lower is the most practical choice for most Pompano Beach homes. The aluminum frame handles salt-air exposure better than untreated steel, the thermal break reduces heat transfer through the frame (important given Pompano Beach’s sustained summer temperatures), and the Low-E coating meets Florida Energy Code’s SHGC requirement while reducing cooling load. Brands we source and install regularly include PGT WinGuard and CGI SentryGlas – both are Florida-manufactured, both carry approvals for Broward County’s wind-speed zones, and both are available in configurations that fit standard rough openings. Call (754) 714-6540 to discuss which specification fits your opening and your budget.
About Patio Door Installation in Pompano Beach
Pompano Beach sits in Broward County’s High-Velocity Hurricane Zone designation, which makes door and window specification a more consequential decision here than in markets without that wind exposure. A patio door is also typically the largest glass opening in a home, which means its U-factor and SHGC values have a measurable effect on cooling costs – relevant in a market where air conditioning runs eight to nine months of the year. The Patio Door Installation in Pompano Beach service page covers the full project scope: product selection, permitting, installation, and the 365-Day Done Right Promise that backs the workmanship.
Rowan Construction Group has delivered more than 4,000 projects since 2007, every one with a written price before work started and a documented photo record when the crew left. Grant Rowan built the company on one administrative discipline: no change proceeds without a signed change order. That’s what keeps projects within a few percent of the agreed number – not optimism, but paperwork. If you’re comparing estimates, bring the competing quote; the Free Second Opinion review is free and takes about twenty minutes. You can read more about how we approach residential construction across all seven trades on our home page.
East of Federal Highway, south of Sample Road, west of the Intracoastal – wherever the project is in Pompano Beach, the process is the same: written price, written scope, signed before anyone starts. Call (754) 714-6540 to schedule a free estimate. A live person answers.
Written by Grant Rowan, Owner at Rowan Construction Group, serving Pompano Beach since 2007.
Pricing reflects the Pompano Beach market as of 2026. Rowan Construction Group Pompano Beach offers free estimates – call (754) 714-6540.
What Our Customers Say
"They found an old septic line under the driveway run and stopped, documented it, and re-quoted before continuing."
- Xavier L."Good communication throughout. Weekly written update meant I never had to chase them."
- Nadine G."Driveway replaced properly with a base that will actually last. They explained why the cheaper quote was cheaper."
- Reggie O.